Socket Mobile Ethernet Blaster Communications Cable Instrukcja Użytkownika Pobierz pdf (Strona 16)

1–12 Altera Corporation

EthernetBlaster Communications Cable User Guide December 2004

Cable Setup

Figure 1–8. EthernetBlaster Change Settings Page

3. Click Apply. The EthernetBlaster communications cable

automatically restarts. When the status LED returns to a steady

green state, the EthernetBlaster communications cable has

successfully restarted and can now be added to the Quartus II

software. See “Setting Up the EthernetBlaster Hardware in the

Quartus II Software” on page 1–13.

Configuring the EthernetBlaster Hardware to Use Dynamic IP

Addressing

To configure the EthernetBlaster communications cable to use dynamic

IP addressing, follow the directions below:

1 Depending on your connection mode, this section assumes that

you have completed the steps in “Remote Connection via

Network Using Default Factory Settings” on page 1–5, or

“Direct Connection to a Computer Using Default Factory

Settings” on page 1–8.

1. Open the EthernetBlaster Status page.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Brak uwag

Socket Mobile Ethernet Blaster Communications Cable Instrukcja Użytkownika Strona 16